Fall Harvest Bracelet

Project details:

Multi layers of fall hues will have you ready for sweater weather. This is a lightweight, easy to wear design that can be stacked with some of your favorite wrist accessories.

↓ Step-by-step

↓ Buy the supplies

Supplies you’ll need:

Linhasita PE-4 (1mm) cord in 4 colors I used (purple, olive green, metallic copper, and natural.) Tawny would look lovely in place of the natural, I listed it as an option in the product list.
8/0 seed beads
lighter
scissors

Step-by-Step Instructions:

Step 1

Cut three 5" pieces of each color of cord. Pick one of the colors and cut two 10" pieces of it. Wrap the cord around the tail end twice as shown and knot. You will want the knot on the backside. Lightly burn the knot with a lighter to seal the cord. You now have two tails hanging out to the side.

Step 2

Slide one seed bead onto each cord. Take the other 10" piece of cord and wrap it twice around the cord ends and knot.

Step 3

Tape down the end of the bracelet. Grab the two cords on one end, twist them both tightly in the same direction. Then start twisting them together in the opposite direction until you have about 3" of twisted cord. Knot at the end. Lightly burn the knots to seal the cord.

Step 4

Trim the ends of the multi strands and burn the ends to seal them.

Step 5

Cross one twisted cord over the other. Cut one 6" piece of cord the same color or different. Tie it on over both twist cords. Start creating a square knot.

See Tip: Tying the Sliding Square Knot