Bunny Bracelet

Step 1

Slide a bunny bead onto an eye pin. Trim off the excess wire, leave just enough that will fit onto the 3mm glass pearl. Dot the wire with super glue and glue on the glass pearl. No wire should be stiking out of the bottom of bead. This is the "bunny tail".

Step 2

Cut the chain to fit your wrist. Use the jump rings to attach the toggle clasp. Attach the bunny to the ring of the toggle.

Step 3

For the larger carrots: Slide a 3mm Czech glass bead onto a head pin, then the 4mm Czech glass bead, and an 8/0 seed bead. Use pliers or a looper tool to create a loop at the top. Make two of these.

See Tip: Wire Wrap a Charm

Step 4

For the smaller carrots: Slide a 3mm Czech glass bead onto a head pin then an 8/0 seed bead. Use pliers or a looper tool to create a loop at the top. Make three of these.

Step 5

Attach the bead charms onto the bracelet with jump rings. For the cupped other of pearl flowers use the bigger jump rings to attach them to the bracelet.